Kubernetes Docker Dashboard How To Use Kubernetes
Kubernetes Docker Dashboard Software Technology Providing

The Linux Foundation has registered trademarks and uses trademarks.

This command creates and configures a Virtual Machine that runs a single-node Kubernetes cluster.

This command also configures your kubectl installation to communicate with this cluster.

To switch back to this context, run this command: kubectl config use-context minikube.

Kubernetes Docker Dashboard Software Technology Providing

You need to be running Linux and to have Docker Docker is a software technology providing operating-system-level virtualization also known as containers.

Those side effects mean that the none driver is not recommended for personal workstations.

Reusing the built-in daemon means you dont have to build a Docker registry on your host machine and push the image into it.

Instead, you can build inside the same Docker daemon as Minikube, which speeds up local experiments.

Because:latest is the default value, with a corresponding default image pull policy of Always, an image pull error ( ErrImagePull ) eventually results if you do not have the Docker image in the default Docker registry (usually DockerHub).

To use this feature, you can use the --extra-config flag on the minikube start command.

To change the LeaderElection.LeaderElect setting to true on the scheduler, pass this flag: --extra-configscheduler.LeaderElection.LeaderElecttrue.

This command shuts down the Minikube Virtual Machine, but preserves all cluster state and data.

Starting the cluster again will restore it to its previous state.

This command shuts down and deletes the Minikube Virtual Machine.

This context contains the configuration to communicate with your Minikube cluster.

These PersistentVolumes are mapped to a directory inside the Minikube VM.

These are not configurable at the moment and different for the driver and OS you are using.

When Kubernetes attempts to schedule containers using Docker, the Docker daemon may require external network access to pull containers.

To do this, pass the required environment variables as flags during minikube start.

To by-pass proxy configuration for this IP address, you should modify your noproxy settings.

If you are posting to the list please prefix your subject with minikube.

Kubernetes Docker Dashboard How To Use Kubernetes

If you have a specific, answerable question about how to use Kubernetes, ask it on.

Kubernetes Docker For Mac Dashboard